top of page
  • Writer's pictureShannon Mutschelknaus
    • Aug 11
    • 1 min read

Heat Exchanger tube installation.

4" corrugated tubes are installed in two layers (4' & 2' deep). Within each layer, tubes are spaced every 16". For experimental purposes, every tube is routed individually without a manifold. This will allow full control of the airflow in each pipe to capture performance characteristics of a wide range of airflow rates.


13 views0 comments

Recent Posts

See All

The last two blocks to haul! These 2'x2'x6' blocks will be used as thermal heat storage for the high tunnel research project. Many growers' sites may not allow excavation for a climate battery due to

bottom of page